Zhejiang Qianjiang Motorcycle RKV 200 Service Manual download pdf (Page 56)

premature component wear.

Refilling engine oil of poor quality or different types or brands will reduce lubrication effects.

When the engine stops, clean dust on the oil level indicator on the right side cover with a piece of

clean cloth.

Stand the engine on a horizontal plane and check oil level in the oil level indicator.

If oil level is lower or approaches the lower limit (-L), add recommended oil to the upper limit

mark (-H).

Engine oil replacement

Warm up the engine.

Place an oil pan below the engine and remove the drain plug and oil

filler plug.

Kick start engine several times to drain thoroughly the engine oil.

After drainage, inspect and clean engine oil filter.

Be sure that filter screen, spring, O ring, drain plug (1) and sealing ring

(2) are perfect and then put them back onto the engine.

* Attention

Oil should be changed when the engine is warm. Place the

engine on the side stand. Make sure all the engine oil is

completely and quickly drained.

When the drain plug is removed, engine oil filter and spring

will be ejected.

Tighten the drain plug.

Add recommended engine oil into the crankcase.

Install engine oil filler plug. Start the engine and let it run for

2~3minutes at idle.

Stop the engine and check if engine oil level is at upper limit

mark in a few minutes.

Stand the engine vertically on the ground to check oil level.

Make sure no oil leaks.

Drive chain slackness

Stand vertically the motorcycle on the flat ground and check

drive chain slackness

○

a .

Drive chain slackness: 10-20mm

If the drive chain does not meet the specification, adjust it.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 170 171

No comments

Zhejiang Qianjiang Motorcycle RKV 200 Service Manual Page 56