Zhejiang Qianjiang Motorcycle RKV 200 Service Manual download pdf (Page 9)

Slack cable implies potential safety hazard on electrics.

Check the next cable when the cable is clamped to ensure

electric safety;

Cable clamp shall not be bent towards solder joint;

Tie the cable at appointed position;

Don’t lay the cable at the end of frame or at the closed angle;

Don’t lay the cable at the tip of a bolt or screw;

Wiring of cable shall be away from heat source or places

where cable may be clipped while moving;

Prevent the cable from being pulled too tightly or slacking

too much when the cable is wired along the handlebar pipe.

The cable shall not be affected by any adjacent components

at any turning place;

The cable shall be wired smoothly and shall not be knotted or

twisted;

Check if sheath of connector is damaged and if connector is

over stretched before butt connection;

If cable runs around the closed angle or the corner, please

protect it with tape or hose;

Tie the cable with adhersive tape reliably after repair;

Controlling cable shall not be bent or twisted. Broken

Controlling cable may result in non-flexible control.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 170 171

No comments

Zhejiang Qianjiang Motorcycle RKV 200 Service Manual Page 9